Contact lenses require the wearer to obtain a prescription outlining the type to purchase even if they are not meant for correction of vision. During physical examination of the eyes, the optician checks for astigmatism, hyper myopia, myopia and general eye health. Your visual strength will also be tested before prescription of Sacramento contact lenses.
In the process of their insertion, the first step should always be washing of hands. They should be adequately dried after that. Then, with your dominant hand, hold the tip of the lens with your index finger and bring down the lower eyelid.
The pointer finger is also used to elevate the lid at the top besides holding lenses. You should look up at this point and place the lens in a gentle manner on the lower side of the sclera. The pointer finger is then removed and the lid released. After doing this, the eye should be closed for a moment to give a chance for the lens to be centered.
When taking them out, again you start with hand washing and drying them thereafter. While gazing upwards, the lower lid is pulled downwards using the dominant hand middle finger. The pointer finger is then used to slide out the lenses by squeezing it between the finger and the thumb. Given the delicate nature of the lens and the sensitivity of the eye, this should be carried out with a lot of caution.
The disposable kind of contact lens is meant to be worn only one time. They eliminate the hassle of repeated cleaning and storing. However, caring for lens is not so difficult. Just make sure you adhere to the instructions of your optician. There are commercially made solutions meant to remove proteins, clean, rinse and disinfect the lenses before they are stored.
There are some steps to be followed in maintenance of healthy ad relaxed use of these lens. The initial step in this procedure is rubbing the lens for around 20 seconds after application of a cleanser on its sides. The rinsing process must be thorough taking up to 5 seconds using a special rinsing solution.
After the rinsing, they should be put inside a lens case and soaked using a cleansing solution for around 4 hours. The solution used for soaking should always be fresh and discarded immediately after use. After this, you can confidently put on lenses. If there is debris on the lenses surface, they can be done away with using a rinsing solution before being worn.
They should be put into a closed case meant for storing lenses if they are not in use. Saline solution should not be used for soaking them. Only the commercially made solutions designed for this purpose are to be used. The saline is not effective in disinfection process. They can remain in the case for up to thirty days if not in use. After this duration, they should be taken out for cleaning and disinfection even if they will not be used immediately. Another important thing you should observe is monthly replacement of the lens case.
In the process of their insertion, the first step should always be washing of hands. They should be adequately dried after that. Then, with your dominant hand, hold the tip of the lens with your index finger and bring down the lower eyelid.
The pointer finger is also used to elevate the lid at the top besides holding lenses. You should look up at this point and place the lens in a gentle manner on the lower side of the sclera. The pointer finger is then removed and the lid released. After doing this, the eye should be closed for a moment to give a chance for the lens to be centered.
When taking them out, again you start with hand washing and drying them thereafter. While gazing upwards, the lower lid is pulled downwards using the dominant hand middle finger. The pointer finger is then used to slide out the lenses by squeezing it between the finger and the thumb. Given the delicate nature of the lens and the sensitivity of the eye, this should be carried out with a lot of caution.
The disposable kind of contact lens is meant to be worn only one time. They eliminate the hassle of repeated cleaning and storing. However, caring for lens is not so difficult. Just make sure you adhere to the instructions of your optician. There are commercially made solutions meant to remove proteins, clean, rinse and disinfect the lenses before they are stored.
There are some steps to be followed in maintenance of healthy ad relaxed use of these lens. The initial step in this procedure is rubbing the lens for around 20 seconds after application of a cleanser on its sides. The rinsing process must be thorough taking up to 5 seconds using a special rinsing solution.
After the rinsing, they should be put inside a lens case and soaked using a cleansing solution for around 4 hours. The solution used for soaking should always be fresh and discarded immediately after use. After this, you can confidently put on lenses. If there is debris on the lenses surface, they can be done away with using a rinsing solution before being worn.
They should be put into a closed case meant for storing lenses if they are not in use. Saline solution should not be used for soaking them. Only the commercially made solutions designed for this purpose are to be used. The saline is not effective in disinfection process. They can remain in the case for up to thirty days if not in use. After this duration, they should be taken out for cleaning and disinfection even if they will not be used immediately. Another important thing you should observe is monthly replacement of the lens case.
About the Author:
You can visit adairoptometry.com/ for more helpful information about On Caring For Sacramento Contact Lenses.